Technical Data for Teltonika FM1204

Battery

1800mAh LiPo acco: the internal accu lasts for 10 to 12 hours with standard operation or 2-3 days in sleep mode or up to 30 days in deep sleep mode without any movement (theoretically)

Stromverbrauch / Spannung

Full operation

Sleem mode (after approx. 5-10 minutes without movement)

Deep sleep (optional)

Operating voltage

approx. 110 mA @12 VDC

approx 20 mA

under 2 mA

10V -30V

  Device cannot be reached 

Navigate LED operation (GPS Signal)

If ignition is ON and connected, the Navigate LED must blink every second.

Behavior
Meaning
Permanently switched onGPS signal is not received
Blinking every secondNormal mode, GPS is working
Off

GPS is turned off because of deep sleep mode

Or GPS antenna short circuited

Status LED operation (GSM)

If ignition is ON and connected, the LED must blink every second and faster if data is transferred.

Behavior
Meaning
Blinking every secondNormal mode
Blinking every 2 secondsDeep sleep mode
Blinking fast for a short timeModem activity
Blinking fast constantlyBoot mode
Off

Device is not working or device firmware being flashed

 

Positioning of the device with GPS antenna insde the device

The device shall be placed UNDER the plastic dashbord with the sticker showing to the sky.

 

Positioning of the device (optional)

If acceleration plays a role, the device should be positioned horizontally and the main wire should show to the back or in driving direction

 

Standard installation with main power, ignition and ground


 

PIN

Meaning

Colour

Necessary

Description


VCC (10-30) V DC

red

yes

Main Power +6 V  - 30 V Direct Current


GND (12-30) V DC

blue

yes

Ground


DIN 1 / IGN

yello

yes

ignition power

 

Note that

 

Installation Tests:

Data with ignition ON and OFF and the gps position must be shown in the test tool.

see Installation Tests and Reporting

 

Connection with additional input (private switch)

 

PIN

Meaning

Colour

Necessary

Description


VCC  V DC

red

yes

Main Power +6 V  - 30 V Direct Current


GND  V DC

blue

yes

Ground


DIN 1 / IGN

yello

yes

ignition power

 

 DIN 2greyoptionalprivate switch

 

Anschluss mit Fahrererkennung (iButton)

 

Meaning

Colour

Necessary

Description

VCC (10-30) V DC

red

yes

Main Power +11,8 V  - 30 V Direct Current

GND (12-30) V DC

blue

yes

Ground

DIN 1 / IGN

yellow

yes

ignition power

1W.datagreenunbedingtiButton reader white wire

GND (12-30) V DC

blue

unbedingt

iButton reader grey wire connect to ground

OUT1whiteunbedingtblack wire of alert buzzer (negative output)

VCC (10-30) V DC

red

unbedingt

red wire of alert buzzer (main power)

DIN 2greyoptionalPrivat switch (to main power)

 

Installation Tests:

The driver identification is managed by the software. The test will only work if the standard mode "logoutmode=2" is used.

If ignition is ON, the buzzer must start to beep. If you place the ibutton chip on the reader, the buzzer must stop

see Installation Tests and Reporting